What we fix in Maple Valley
Won’t fire, won’t start
From a tripped safety to a failed hot surface igniter, we run the sequence the furnace runs and stop where it stops.
Blowing cold
Cold air on a running furnace means the burners aren’t staying lit or the limit switch is cutting them — both fixable in one visit.
Cycling on and off
Two-minute run cycles waste gas and wear parts. Usually a dirty flame sensor, a blocked filter or an oversized-for-the-ducts problem.
Parts on the truck
Igniters, flame sensors, capacitors, pressure switches and boards for the common brands, replaced with the price approved first.
Maple Valley, cold house?
We’re about 10 minutes away. Book now — tech contact within 1 business hour, price upfront.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
We know Maple Valley
Maple Valley grew fast in the 2000s, so Four Corners, Lake Wilderness, Elk Run and Cherokee Bay are largely the same generation of house — and the same generation of furnace. Builder-installed gas furnaces from 2000–2010 are now 15 to 25 years old, which is prime time for igniter, inducer motor and pressure switch failures, often on the first cold night of the year. The older lakeside homes around Lake Wilderness and Pipe Lake are a different story, with tighter mechanical rooms and older venting. Our Covington shop is about 10 minutes from any of it.
Before you call (5 minutes, free)
- 1
Is the furnace switched on? The switch beside the furnace, then the breaker in the panel. One reset, no more.
- 2
Thermostat batteries and mode. Fresh batteries, HEAT selected, setpoint above the room temperature.
- 3
Blower door fully closed. If it isn’t clicked in, the safety switch keeps everything off.
- 4
Filter and outdoor vent pipes. A packed filter overheats it; a PVC intake or exhaust pipe blocked by snow, leaves or a nest shuts it down.
No luck? That’s a technician job. The earlier it’s booked, the earlier the heat is back on. Book the visit →
Stop and book a pro if…
- A gas smell — leave, then call PSE before calling us.
- CO alarm sounding, or the family feeling headachy indoors.
- A breaker that trips again immediately after a reset.
- Repeated ignition attempts with no flame, or soot around the burners.
Why homeowners hand it to us
- You approve the price first. Upfront quote before a single screw turns.
- Same-day service. Book in a minute, hear from a tech within 1 business hour.
- 500+ jobs done by 4.9★ rated, professional technicians.
- Fixed right, guaranteed. If it’s not right, we make it right.
Quick answers
How quickly can you reach Maple Valley?
About 10 minutes from our Covington shop — you’re next door. Book online and a tech reaches out within 1 business hour; most no-heat calls here are same-day.
What does a furnace repair cost in Maple Valley?
Common furnace repairs sit in a typical industry range of $150–$700 — igniters and sensors low, motors and boards high. The exact price is shown before work starts, and nothing happens until you approve it.
My furnace is original to the house. Repair or replace?
We quote the repair first and give you a straight opinion on the unit’s remaining life. Many 2000s furnaces have years left after one honest repair.
Ten minutes away, right now
Book the visit and a tech reaches out within 1 business hour. Price approved before any work.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
More: furnace repair service · furnace troubleshooting · repair costs · 24/7 emergency
Furnace repair nearby: Covington · Kent · Auburn · Renton · Federal Way · Puyallup · Des Moines · Burien · Tacoma