What we fix in Auburn
Dead furnace
Power, safety switches and ignition are checked in order. When it’s a failed igniter or board, the part usually goes in the same visit.
Cold air from the vents
Cold air with the furnace running is a setting, a sensor or a heat exchanger safety doing its job. We find which before anything gets replaced.
Loud, smelly or shaking
Startup booms, squealing blowers, burning smells — specific parts, specific fixes, and a straight answer about whether it’s safe to keep running.
Old furnace, honest answer
On a 25-year-old unit we quote the repair and tell you plainly whether it’s worth it. No pressure either way.
Auburn, no heat?
Book now and a tech reaches out within 1 business hour. Same-day on most calls, price upfront before any work.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
We know Auburn
Auburn covers the whole spread of Puget Sound housing. The downtown and North Auburn ramblers date from the 1940s to the 60s and often carry a gas furnace that replaced an oil unit decades ago, sitting in a tight hall closet or a garage corner. Lea Hill’s 1990s subdivisions and Lakeland Hills’ late-90s and 2000s two-stories are the opposite problem: original builder furnaces all reaching 20–30 years at once, so igniters, inducers and control boards fail on schedule every winter. We’re 15 to 20 minutes out from Covington, and Lea Hill is on the near side.
Before you call (5 minutes, free)
- 1
Furnace switch, then the panel. The switch on the furnace or the wall beside it is off more often than anyone admits. One breaker reset only.
- 2
Thermostat sanity check. New batteries, HEAT mode, setpoint above the room — then listen at the furnace for a click within a few minutes.
- 3
Re-seat the blower door. Push until it clicks flush. The safety switch behind it keeps the furnace off otherwise.
- 4
Check for water at the base. High-efficiency furnaces shut down when the condensate drain backs up. Water on the floor is the clue.
If it’s still cold, stop there — the rest needs a technician, and same-day is the fastest way back to a warm house. Book the visit →
Stop and book a pro if…
- Any gas smell — out of the house, then PSE’s gas line.
- Carbon monoxide alarm, even a brief one.
- A breaker that won’t stay on.
- Scorch marks, a hot electrical smell, or a furnace cabinet that’s too hot to touch.
Why homeowners hand it to us
- You approve the price first. Upfront quote before a single screw turns.
- Same-day service. Book in a minute, hear from a tech within 1 business hour.
- 500+ jobs done by 4.9★ rated, professional technicians.
- Fixed right, guaranteed. If it’s not right, we make it right.
Quick answers
How long to get to Auburn?
About 15 to 20 minutes from our Covington shop; Lea Hill is closer. Book online and a tech reaches out within 1 business hour — same-day on most Auburn no-heat calls.
How much does furnace repair cost in Auburn?
Typical industry range: $150–$700 for the common failures. A flame sensor or igniter is the low end; a blower motor or control board the high end. We quote your exact price upfront and wait for your OK.
Do you handle older downtown homes?
Yes. Older Auburn ramblers with converted or tight-closet furnaces are routine for us, and we’ll tell you honestly when a repair still makes sense on an aging unit.
Get the heat back on
Same-day furnace repair across Auburn. Book now — tech contact within 1 business hour.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
More: furnace repair service · furnace troubleshooting · repair costs · 24/7 emergency
Furnace repair nearby: Covington · Kent · Maple Valley · Renton · Federal Way · Puyallup · Des Moines · Burien · Tacoma