What we fix in Covington
No heat, no start
Dead furnaces are usually power, a safety switch or a failed igniter. We find which one and fix it the same visit whenever the part is on the truck.
Cold air or short cycles
A furnace that runs but never warms the house, or fires and quits every couple of minutes, is telling on a sensor, a filter path or an overheating heat exchanger.
Noises and smells
Booms on startup, screeching blowers, a burning or gas smell — each points to a specific part, and some of them mean stop using the furnace tonight.
Igniters, boards, blowers
The parts that actually fail: hot surface igniters, flame sensors, pressure switches, control boards, inducer and blower motors. Replaced with the price shown first.
No heat in Covington tonight?
We’re already in town. Book now and a tech reaches out within 1 business hour, price upfront before any work.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
We know Covington
Covington is home base, so Timberlane, the Jenkins Creek neighborhoods and the houses along the SE 272nd and Wax Road corridors are our shortest drives of the day. Most of the housing here went up in the 1990s and 2000s, which puts a lot of original builder-grade gas furnaces at 20 to 30 years old — the age when igniters, inducer motors and control boards start quitting one after another. We also see plenty of newer builds where the furnace is fine but the thermostat or a clogged condensate line is the real culprit.
Before you call (5 minutes, free)
- 1
Furnace switch and breaker. The switch by the furnace gets bumped off; check it, then the panel. Reset a breaker once, never twice.
- 2
Thermostat first. Fresh batteries, HEAT mode, setpoint a few degrees above the room.
- 3
Blower door seated. A door panel that isn’t clicked in holds the whole furnace off after a filter change.
- 4
Filter and vents. A choked filter overheats the furnace and shuts it down; swap it and open the closed registers.
Still no heat? Then it’s a technician job — and the sooner it’s booked, the sooner the house is warm again. Book the visit →
Stop and book a pro if…
- You smell gas — leave the house, then call PSE’s gas line before anyone else.
- The CO alarm has gone off, even once.
- The breaker trips again right after a reset.
- It clicks and tries repeatedly but never lights — stop retrying.
Why homeowners hand it to us
- You approve the price first. Upfront quote before a single screw turns.
- Same-day service. Book in a minute, hear from a tech within 1 business hour.
- 500+ jobs done by 4.9★ rated, professional technicians.
- Fixed right, guaranteed. If it’s not right, we make it right.
Quick answers
How fast can you get to my Covington home?
Fastest of anywhere — our shop is in Covington. Book online and a tech reaches out within 1 business hour, with same-day service on most no-heat calls.
What does furnace repair cost in Covington?
Most common furnace repairs land in the typical industry range of $150–$700: igniters, flame sensors and switches at the low end, blower motors and control boards higher. You get the exact price upfront and approve it before we start.
Which neighborhoods do you cover?
All of Covington — Timberlane, Jenkins Creek, the Wax Road and SE 272nd corridors, the Pipe Lake side — plus Maple Valley, Kent and Black Diamond next door.
Warm house by tonight?
Same-day furnace repair from your own town. Book now — tech contact within 1 business hour.
Book My Same-Day Visit60 seconds online · or call (206) 486-6373
More: furnace repair service · furnace troubleshooting · repair costs · 24/7 emergency
Furnace repair nearby: Kent · Auburn · Maple Valley · Renton · Federal Way · Puyallup · Des Moines · Burien · Tacoma