What we fix
Rheem and Ruud gas furnaces.
- No heat or blowing cold air
- Lights, then shuts off (short cycling)
- Igniter and flame sensor
- Inducer motor and pressure switch
- Blower motor and capacitor
- Control board and limit switches
Good to know about Rheem
A number, not a blink
Rheem furnaces show a code on a small display. On most models the two digits appear one after the other. A single 0 means standby, not a fault.
Rheem and Ruud are the same
Same manufacturer, same equipment, same control boards and codes. We repair both.
Warranty
Rheem gives you 90 days to register. Unregistered equipment gets roughly half the parts coverage.
Rheem furnace down right now?
Book in about a minute. A technician reaches out within 1 business hour, and you approve the price before any work.
Book Rheem Furnace Repair60 seconds online · or call (253) 766-4822
How it works
- 1
Book online or call. Tell us it’s a Rheem and what it’s doing. The model number off the label helps.
- 2
A technician reaches out within 1 business hour. We come out, find the fault, and show you what we found.
- 3
You approve the exact price first. Nothing starts until you say go.
Where we repair Rheem furnaces
From our base in Covington.
King County
Covington, Kent, Renton, Maple Valley, Black Diamond, Auburn, Enumclaw, Federal Way, Des Moines, Pacific, Algona, Burien, SeaTac, Tukwila, Issaquah, Newcastle, Snoqualmie, North Bend, South Seattle
Pierce County
Tacoma, Puyallup, Lakewood, Sumner, Bonney Lake, Lake Tapps, Orting, Buckley, Graham, Spanaway
Not on the list? Book it anyway and a technician confirms within 1 business hour.
Why homeowners call us
- You approve the price first. Exact price upfront, before any work starts.
- We answer 24/7. A technician reaches out within 1 business hour.
- 500+ jobs done by 4.9★ rated technicians. Licensed & insured.
- Fixed right, guaranteed. If it’s not right, we make it right.
Rheem furnace repair questions
Do you repair a Rheem you didn’t install?
Yes. Rheem asks for a qualified HVAC professional working to code, not a particular dealer.
My Rheem display shows a number. What should I do?
Write down both digits in order and add them to your booking. Our Rheem code guide is linked at the bottom of this page.
Do you repair Ruud furnaces?
Yes. Ruud is the same equipment as Rheem.
How much does a furnace repair cost?
Typical Western Washington furnace repairs run $150–$700. It depends on the part, not the brand. Industry range, not a quote. Your exact price comes upfront and you approve it first.
Can you come out today?
Same-day service is available, and no heat in a cold snap gets priority. A technician reaches out within 1 business hour.
Get your Rheem furnace working again.
Same-day service. Exact price upfront, before any work starts.
Book Rheem Furnace Repair60 seconds online · or call (253) 766-4822
Next Phase Heating & Cooling is an independent HVAC contractor, not a dealer for Rheem or any other manufacturer. Brand names are used only to identify the equipment we repair.
More from our site
Furnace won’t turn on · Furnace blowing cold air · Igniter replacement · No heat emergency